Maytag Washer Restore Help, Neptune Washer Troubleshooting and How To Entry

This washer and dryer set has been about for some time now, the 3000 sequence could be practically 12 years outdated.

Accessing the washer’s principal factors is mostly carried out from the front, to remove the again is basic, I will explain “How To” at the end of this article.

The first phase in accessing your washer is to take away the screws close to the door body. There are two screws found on the doorway hinge and two directly opposite. dryer repair will require to be taken out to acquire entry into the within of the washer.

With the front off the washer, the drain pump, motor manage board and numerous other parts will be obvious and available. The motor management on the correct is acknowledged for going out, if your washer stopped spinning, presents an LR error code, this motor management is the likely offender. Cleansing the pump can be done from the front or the back, the back again panel is held tight with four screws. The only trick to acquiring the again panel again on is to snap the plastic on to the metallic ahead of the panel is mounted.

If you are 1 of the unfortunate types working with the wax motor control board malfunction, you are not alone, the leading of the washer will need to have to be lifted in purchase to gain access.

To do so the 4 screws below the soap dispenser will want to be eliminated, these are the screws the arrows are pointing to in the picture on leading of the washer.

In buy for the leading carry free the two corner brackets will require to be taken off, if you have presently taken out the screws around the doorway body and the entrance is off you will see the two brackets that hold the prime down, one 5/16 screw holds every bracket.

With the four screws taken out from the soap cup housing and the two steel clips, the top will raise up.

Leave a reply

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>